Equipment Specifications Library

Basic Model Information

  • Manufacturer:
    Vac-Tron
  • Model:
    PMD550D

View Manufacturers View Models

Specifications

Length 148" 376 cm
Width 34" 86 cm
Height 75" 190 cm
Weight 3,200 lbs 1,451 kg

Additional Info

DIMENSIONS
Length: 148" (376 cm)
Width: 34" (86 cm)
Height: 75" (190 cm)
Empty Weight (no trailer): 3,200 lbs (1,451 kg)

GENERAL
-Lockable Curbside Remote Controls
-Hydraulic Pump and Hydraulic Cylinder with Remote Controls to raise tank 60 degrees
-6" Brass Rear Discharge Valve
-6" Stainless steel Portal Shut-off in top of Vacuum
Tank
-30 Gallon Fuel Tank with fuel gauge located in curbside
control panel
-6" Amber Strobe with Two adjustable Halogen Work
Lights mounted at rear of tank
-OSHA Certified
-Winterization Package with 15 Gallon semi-automatic
antifreeze system

ENGINE ENCLOSURE
-Fully enclosed and insulated to eliminate noise and vibration using 2/3 open cell attenuation material
-All components attached to an isolation plate that is mounted within the engine enclosure using isolation mounts
-All 4 sides of engine enclosure are removable
-All service points for engine, water pump, and vacuum
pump are accessible from curbside
-Silencer for Vacuum Pump (Mounted within the enclosure
and not to exceed 80 DBA at full performance)
-High Pressure Water Pump to be Completely Inside Enclosure

FILTRATION
-Bag House (Big Red) - with 100 square feet filtration media, combined with 10-gallon water trap
-Filtration cylinders are washable and removable
-WET or DRY industrial filters rated at 5:1 air cloth ratio and grain loading of 30-g/acf using 0.5-micron silica dust emissions of .0060 g/acf

WATER
-4000 PSI Water Pump powered by same engine
-Electric clutch with on/off control and low water automatic shut-down
-325 Gallon Poly Water Tank plumbed to high pressure
pump
-50' of high pressure hose rated at 4000 PSI
-Manual locking hose reel
-5' Roto Wand and Control handle
-3' Variable Nozzle Wand for clean up
-8 Gallon semi-automatic antifreeze system

TANK
-UHMW Tank liner on bottom of debris tank
-6" Brass Rear discharge valve with dust cap
-Large 6" stainless steel Portal Shut-off (stops vacuum when debris tank is full)

-36 HP Yanmar water cooled diesel engine
-550 CFM Vacuum Pump capable of 15" of mercury (Utilizes a "one piece" steel lobe and shaft design)
-500 Gallon debris tank with Hydraulic Lift Dump
-Hydraulically Operated Full Open Rear Door
-Hydraulically Locked Rear Door
-33' of 3" light weight smooth bore rubber Suction Hose (industrial rated)
-Two 3" light weight dielectric Suction Wands (4' and 6')

View Manufacturers View Models

This information is provided for informational purposes only. HDD Broker LLC cannot warrant the accuracy or completeness of this information. This information is subject to change by the manufacturer. Some specifications may vary by model year.

HDD Broker uses cookies and collects personal information on its websites.

To learn more, review HDD Broker's Privacy Policy and Cookie Policy. By clicking "I Accept", you indicate you have adjusted your browser settings to fit your preferences and consent to HDD Broker's use of cookies.

x